Navigation:  Calculation Modules > Miscellaneous Calculation Modules >

Rebar Development Table

Previous pageReturn to chapter overviewNext page

 

Need more? Ask Us a Question

 

This module calculates development and splice lengths for deformed steel rebar in concrete. Since typical development lengths are readily available in tables, this module is primarily for developing tables of development lengths when unusual conditions affect the lengths.

 

The module uses ACI 318-05 sections 12.1, 12.2, 12.3 and 12.5 for straight tension & compression development and hooked tension development.

 

Two major categories of development calculation are available; straight development and hooked development. The module calculates the basic tension development length for straight and hooked cases, and compression development for straight cases only.

 

clipp292

 

Item Descriptions

 

Print This Information

Check this box if you want the development calculation on the current tab to appear on the printout.

 

This Bar

Enter a description for the current development calc.

 

Bar Details

Enter the basic stress info for this bar. You can also select to perform the calculation according to ACI 318-91.

 

Straight Development

This section performs tension & compression bar development according to ACI section 12.2 and 12.3. Please refer to the ACI code for the proper definitions of these entries.

 

Hooked Development

This section performs tension hooked rebar development according to ACI section 12.5. Please refer to the ACI code for the proper definitions of these entries.